It is finished, the inlays are in the fretboard.
I could now dwell on the details, but that is really unnecessary.
The most complicated piece of work is behind me, And this is, after 4h milling and 3 h bonding and grinding out: it is important
that the guitar does not wobble to which I have supported the neck with cork and helps the body with cherry stone pillow.
inlays with Tipp-Ex stick, accuracy will decide at this point about the eventual seating of the inlays.
then outline with a needle.
Then we went off with 180 grit paper,
after 2.5 h and was finally all on one level. Then, with 320s, 400s, 600s and 1200s ground to finish. There goes even more, I was at half past 2 hours in the morning just not fit enough. : Other D
impurities way, I have yet repaired with super glue and sanding dust: a paper towel moistened with universal and dip into dust, then a tiny drop of super glue to give the Verstiefung and immediately roto the sanding dust. Everything that can be taken at the point of adhesive, is pressed into the hole and then wipe the excess from the thinner muck away.
Collapsed very good.
now are some more hurray to Bundi and installing the hardware,!
0 comments:
Post a Comment